Specifications

Mechanical:

Tube PCB with 10mm Standoffs (10mm standoffs are required and 10mm clearance must be present below the PCB):

140mm deep

80mm wide

45mm high

Fixing holes in the four corners on a 71mm X 131mm rectangle. Fixing holes require M3 or equivalent screws.

Mains transformer:

76mm diameter

40mm high

Fixing with either central M4/M5 bolt or via 4 racetrack shaped 8mm X 5mm Holes centered on a 60mm square.

This means for the mains transformer to fit at least 40mm clearance above it is required, the tube stage needs 45mm.

Electrical Performance:

(example only as will vary by implementation):

measurements Iout DAC Mode (=30db gain)

referenced to 2V RMS, Saratov (Reflector/Sovtek) 6N23 fitted

Measurements vary with different tubes fitted

specifications:

● S/N- > 100dbA (approx 5nv/hz).

● THD- <0.15% (<0.1% typical); <1%THD (10Vout, 100K load)

● 20Hz – 20KHz (< -0.5db with IHF 10K/1nf load)

● Output Impedance <100 Ohm

● Can use 6cg7, 6N11,ECC 88, 6DJ8, 6922, 6H1 only