Author: Jasmin

Ultimate Volume Control Drill Template

Read more

Projekt-Universal Tube Output EZ Linestage Manual

Projekt-Universal Tube Output EZ Linestage Manual   Table of Contents Projekt-Universal Tube Output EZ Linestage Manual Electrical Performance 1.1 – Settings and Input wiring for use as SE Linestage 6db Gain 1.2 – Settings and Input wiring for use as SE Linestage 12db Gain   Introduction and Overview The diyhifisupply® Universal Tube Output Stage has […]

Read more

Settings and Input wiring for use as SE Linestage 6db Gain

1.1 – Settings and Input wiring for use as SE Linestage 6db Gain This type of Application requires the following jumper settings: The input connections should follow the Scheme shown underneath: Includes: 1 pc UTS 1 set 70 x 240 x 240mm chassis with faceplate drilled 1 Universal tube Stage including transformer mounted 1 Tesla […]

Read more

Settings and Input wiring for use as SE Linestage 12db Gain

1.2 – Settings and Input wiring for use as SE Linestage 12db Gain This type of Application requires the following jumper settings: The input connections should follow the Scheme shown underneath:

Read more

The Vinyl Song Universal Tube Output Stage EZ Phono Installation

Vinyl Song Universal Tube Output Stage EZ Phono Installation Manual   The diyhifisupply® Universal Tube Output Stage has been designed to offer a State of the Art tube amplification stage, intended to be applied to CD-Players, DVD-Players and DA-Convertors to completely replace the original solid state analogue circuit and phono stages.   There are many […]

Read more

Introduction and Overview

1 – Introduction and Overview   The Vinyl Song is a State of the Art Phono Preamplifier/Equalizer with 38dB (MM) and 62dB/68dB (MC selectable) of gain. By using the Silk 600 Ohm LCR RIAA EQ Modules not only a very precise equalization is attained, but also noise is kept very low. The (optional for the […]

Read more

UTS module Specifications

2 – UTS module Specifications:   2.1 Mechanical:   Tube PCB with 10mm Standoffs (10mm standoffs are required and 10mm clearance must be present below the PCB): 140mm deep; 80mm wide; 45mm high Fixing holes in the four corners on a 71mm X 131mm rectangle. Fixing holes require M3 or equivalent screws.   Mains transformer: 76mm […]

Read more

UTS Settings and wiring

3 – UTS Settings and wiring This application will produce a moving magnet and high output moving coil cartridge compatible Phono stage. It use two Universal Tube Output Stages together with a LCR 600 ohm module to form the RIAA Equalisation network as Phonostage. One UTS Module will be used for each channel, so Tubes […]

Read more

Wiring the chassis and Modules

4 – Wiring the chassis and Modules Please check your Kit content against the list to the right. Take care to first review the steps outlined below, assemble the necessary tools, parts etc. Many of the required connections can be made without using a soldering iron. However the connections for the RCA Jacks and from […]

Read more

Testing and first power-up

5 – Testing and first power-up The modules making up your Vinyl Song Kit are individually tested before shipping. So no extensive testing is required. However, we recommend a set of basic checks before first switch-on. 5.1 Basic testing and checks  Please re-check all the wiring and connections against the drawings and Photos. Check that […]

Read more